WTSML Heat Transfer Technology Co.,Ltd
Add: Qiaoxing Road 150, Torch Industrial Zone, Licheng Area, Quanzhou, Fujian, China
Tel:86 595 22168106
Fax:86 595 22142090
The heat exchanger shall not be formed or assembled by force means such as hammering; the material marking, welder stamping shall not be scored or struck on the pressure component. Pressure components made of steel that has been normalized, normalized and tempered, quenched and tempered are easily formed by cold forming or tempering temperatures. When using warm forming, the heat exchanger must avoid the steel fire brittle zone. If it is thermoformed above the tempering temperature, the same or similar heat treatment as the base metal should be carried out as needed.
The U-shaped elbow adopts a cold pipe, and when the bending radius is less than 10 times the outer diameter of the heat exchange tube, the stress relief heat treatment is performed after the cold bending. For the heat-treated pipe, the same heat treatment as the original heat treatment process shall be repeated after the cold bending of the hot-bending or bending radius of less than 10 times the outer diameter of the heat-exchange tube.
- High Flux Heat Exchanger Technology
- Structure Of Shell And Tube Heat Ex...
- Introduction Of Air Cooler
- The Characteristics Of APV Plate He...
- Type Plate Heat Exchanger Gasket
- Gasket Structure Characteristics
- Heat Exchanger Plate Sealing Principle
- Classification Of Heat Exchanger Ap...
- The Characteristics Of Alfa Laval P...
- The Application Scope Of SONDEX Hea...
- Sondex Plate Heat Exchanger
- Plate Heat Exchanger Unit Plates
- Plate Heat Exchanger Manufacturing ...
- Plate Heat Exchanger Unit
- Brazed Plate Heat Exchanger Applica...
- Brazed Plate Heat Exchangers
- Plate Heat Exchanger Flow Arrangement
- Heat Exchanger Units Advantages
- Plate And Frame Heat Exchanger Adva...
- Gasketed Plate Heat Exchanger Advan...