WTSML Heat Transfer Technology Co.,Ltd
Add: Qiaoxing Road 150, Torch Industrial Zone, Licheng Area, Quanzhou, Fujian, China
Tel:86 595 22168106
Fax:86 595 22142090
Plate heat exchanger manufacturing process inspection
The inspection of the plate heat exchanger equipment manufacturing process, including the inspection of raw materials, the inspection between processes and the pressure test, the specific contents are as follows:
1. Equipment pressure test, including: hydraulic test, medium test, airtight test etc.
2. Inspection of the dimensions and geometry of raw materials and equipment parts
3. Inspection of raw materials and weld internal defects, the inspection method is non-destructive testing, which includes radiation detection, ultrasonic inspection, magnetic particle detection and penetration inspection.
4. Chemical composition analysis, mechanical property analysis test, metallographic structure inspection of raw materials and welds, collectively referred to as failure test.
- High Flux Heat Exchanger Technology
- Structure Of Shell And Tube Heat Ex...
- Introduction Of Air Cooler
- The Characteristics Of APV Plate He...
- Type Plate Heat Exchanger Gasket
- Gasket Structure Characteristics
- Heat Exchanger Plate Sealing Principle
- Classification Of Heat Exchanger Ap...
- The Characteristics Of Alfa Laval P...
- The Application Scope Of SONDEX Hea...
- Plate Heat Exchanger Unit
- Brazed Plate Heat Exchanger Applica...
- Brazed Plate Heat Exchangers
- Plate Heat Exchanger Flow Arrangement
- Heat Exchanger Units Advantages
- Plate And Frame Heat Exchanger Adva...
- Gasketed Plate Heat Exchanger Advan...
- Gasketed Plate Type Heat Exchanger ...
- Heat Exchanger Tube And Tube Sheet
- Plate Type Heat Exchanger Scaling